Grid
List
Actisense USG-2 USB Cable - USB to PC shielded cable
USB cable accessory for use with the Actisense USG-2. Note: The USG-2 ships with this cable included in the box but it is also available as an accessory in case a replacement is needed.
Actisense W2K-2 NMEA 2000 to WiFi Gateway
The W2K-2 is a rugged and reliable NMEA 2000 to Wi-Fi Gateway with built-in data logger. It transfers data from an NMEA 2000 backbone to any device (e.g laptop, tablet or smartphone) connected to it via Wi-Fi and additionally can convert this data to NMEA 0183 using Actisense's renowned conversion engine.
Furuno IFNMEA2K2 NMEA Data Converter
IF-NMEA2K2 The IF-NMEA2K2 is an interface to convert data from NMEA0183 format to NMEA2000 / CAN bus format and vice versa. In addition to the normal conversion mode, the High Speed mode to convert sensor data for Autopilot as well as an AIS mode dedicated to AIS data are available in one compact unit. With these three modes, you can optimize the conversion speed depending on the situational requirements.
Furuno IFNMEAFI Analogue NMEA Converter
The analog to NMEA2000 converter IF-NMEAFI (00002704700) is supplied as an option to connect the wind sensor FI-5001/L or analog tank gauge to the FI-70 network.
Garmin NMEA 2000 Multi-Port T-Connector
Make NMEA 2000 installations easier with our multi-port T-connector. This solution creates a more robust NMEA 2000 backbone by reducing issues with breaking points as well as stress induced by long back bones. The rigid construction is less prone to failure and decreases installation time.
Garmin NMEA2000 1 Port T-Connector
Add components to any NMEA 2000 network by installing this T-connector on the backbone cable. The revised version of this T-connector is offset by 45 degrees compared to the previous version.